nolanlabs

Sound

On this page
  1. Set levels and pan
  2. Add effects
  3. Change speed
  4. Pick channels
  5. Add a sound effect
  6. Hit a loudness target
  7. Let the agent listen
  8. Limits

This page covers how to set levels, put effects on sound, and hit a loudness target on delivery. The timeline plays its sound on the audio clock, and sound from every unmuted track is mixed into renders.

Set levels and pan

  • A track: with nothing selected, the Inspector sets each sound track’s level. A track’s menu has solo and pan.
  • A clip: with a sound clip selected, the Inspector sets its gain, fades and pan.
  • Over time: gain and pan can be keyed, with straight lines between keys, up to 64 of them.
With nothing selected, the Inspector sets each sound track’s level.

A dissolve is a cross fade. A freeze is silent. Pan is equal power: the far side falls and the near side stays.

Add effects

These go on a sound clip in the Inspector, applied in order.

Effect Fields
EQ band Frequency, gain, width
High pass, low pass Frequency
Compressor Threshold, ratio, attack, release, makeup
Limiter Ceiling
Gate Threshold, ratio
De-esser Amount
Reverb Size, mix
Delay Time in ms, feedback, mix
Pitch Semitones
Noise reduction Amount
Normalize Target, in LUFS

Before those, a clip’s sound can go through VST3 effects, and on a Mac Audio Units. See Plug-ins.

Levels and fades without effects are immediate in the viewer. A change to effects, sound plug-ins or keyed levels takes a moment to be heard, because the viewer plays a mixdown of the whole mix, remade when it changes. Solo works either way.

Change speed

A clip’s sound goes at the clip’s speed. A speed ramp keeps its pitch on any curve, including one that goes backwards.

Pick channels

A clip can pick channels of a multi-channel source, so it can take a boom on channel 3. On delivery, a script or the agent sets the master’s channels. Pan is stereo.

Add a sound effect

The editor makes its own: whooshes, impacts, a sub drop, a braam, risers, pops, clicks, ticks, glitches, static, a shutter, a clap, a heartbeat and a rumble. That’s 26 in all, made from noise, tones and filters. The agent brings the ones it uses into the project’s Sound effects bin. Your own are imported like any media.

Hit a loudness target

A limiter on the master holds down the true peak. For a target, set the loudness in Custom on the Deliver page:

  1. The mix is measured as a meter reads it.
  2. Plain gain brings it to the target when that stays under the peak you set. That lands exactly and leaves its shape alone.
  3. Otherwise a second pass of loudness normalizing does it.

A target beyond what the peak allows isn’t reached. The peak wins, and the check after the render says how loud it got.

When a render is done, the editor checks the file for loudness (LUFS), true peak and loudness range, and the queue shows each result.

Let the agent listen

The agent can read a source’s sound as tempo, beats, bars, hits, loudness every half second, quiet stretches and joins for shortening music. It can also read the timeline’s loudness as a render will mix it, by EBU R128, and see a picture of the sound with the cuts over it.

Ask, for example: “cut to the beat”, or “what’s the loudness of this mix”.

Limits

Sound plug-ins go on clips, not on tracks or the master. Surround lays out the master only. See Known limits.

Docs

↑↓ Move↵ Open